I did not want a wire from my radio to my sim usb. There were a few solutions for this but most were bulky and clumsy to use. I got a few parts and put one together myself. Saw the idea a few places, but wanted to write up how I did it.
We need to prep the receiver for use with the USB dongle. We need to activate the PPM on the receiver by jumping the the PPM pads on the receiver, with a wire or a solder jump. (may be a little different depending on the mini receiver)
Next prep the USB board either take off the wire plug or leave it on and use the connections points. It is easier to remove the connector and it give you more room. Connect the pins as shown. (may be a little different depending on the mini receiver)
Once the connections are made tuck everything in nicely. Before putting the case back on I would bind it to a model and test operation.
I recently bought a few RC planes. Part of the purchased was this crashed Flyzone L-39. It was torn up pretty bad. Here is the process I used to fix it and get it flight ready. If you have not viewed Part 1 Please take a look. Part 2
After a few crashes on any foam board plane some parts start to weaken. One of the spots the starts to break or weaken is the power pod. I made a few parts to reinforce the front power pod. They are light and easy to install. They make the whole front of the plane a little more solid. Cut from lightweight birch plywood they work perfect on any Flitetest power pod.
The Kit has 3 peices.
When assembled they form a strong motor mount. The assembly slides easily in the flitetest power pod. Making a stronger power pod.
Here is a quick how to video for the whole process.
I designed a reinforced wingbox that easily mounts in place of the base foam wing supports. Built out of 1/8in birch plywood it is strong without adding to much weight. This mod can be installed during initial build of the FT Spitfire.The kit is also available for the BF-109 variant of the design. It works great and you can still access the power pod. Here is a how to video.
After flying my Flitetest spitfire and my BF-109 (basically the same fuselage), I found my front wingbox getting really weak and started tearing out. So I repaired it multiple times with hot glue but it kept getting weak.
So I designed a reinforced wingbox that easily mounts in place of the foam wing supports. Built out of 1/8in birch plywood it should be strong without adding to much weight.
It works great and you can still access the power pod. Now there is no reason to cut a whole new fuselage when your wingbox weakens. I have created an easy to follow how to video and the parts are available in the Attitude RC store Now!